Instrument and Control Design Engineer 仪表工程师(campus)

Over de functie

Transformation of Industry
Recent Graduate
Let's talk about you 
Your Profile:
•Bachelor or Master degree major in I&C, electrical and automation related preferred.
•Experience below is welcomed:
- I&C design for rotating machinery or related engineering. 
- I&C related standard in petrol and chemical or power or steel industry, eg. IEC, GB, API, etc. 
- explosion proof knowledge and Ex facility selection. 
- product knowledge and working principle in rotating machinery 
- principle and selection of application for instrumentation and control valve and actuator.
- PLC and HMI related knowledgewith good in MS Office, AutoCAD, COMOS.
- Motivation in keeps leaning and teamwork and innovation.
- Experience with Teamcenter & SAP.
- Good communication skills 
- Fluent English in writing & speaking (German welcomed).

Your Responsibilities: 
•Responsible to project perform the design of instrument and control system.
•Design drawings including but not limited,P&I D, instrument list, instruments data sheet, I/O signal list, wiring diagram, control logic diagram, control description, instruments hook up diagram, control circuit diagram, low voltage electrical schematic.
•Specifies and prepares the technical specification of instruments, control valve and control system.
•Check and review the sub-vendor’s technical proposal and drawing document. Support for technical clarification to sub-vendor.
•Designs the mechanic and electric connection of sensors.
•Addresses non-standard and typical requirements of projects from the instrumentation point of view.
•Coordinates and communicates with overseas engineer for project cooperation and products localization. 
•Monitors the I&C technical part for the project contract execution smoothly. 
•Monitors the submission of design documents regarding OTD, expedite and facilitate the achievement of documentation related milestones. 
•Participates at technical meeting with customer, design institute and sub-vendor. 
•Participates at factory acceptance testing of control system.
•Supports site installation and commissioning.
•Provides As-Built documents and supports the MoM preparation.
•Willing to take short-term traveling.